Hustler Z Tractor Owner Manual Hustler Z Super Z Owner’s Manual
This manual applies to the following equipment:
Hustler Z tractor & 60” deck, number 926253
Hustler Z tractor & 60” deck, number 926295
Hustler Z tractor & 52” deck, number 926311
Hustler Z tractor & 52” deck, number 926345
Hustler Z tractor & 60” deck, number 926451
Hustler Z tractor & 60” deck, number 926469
Hustler Z tractor & 72” deck, number 926550
Hustler Z tractor & 72” deck, number 926568
Super Z tractor & 60” deck, number 926360
Super Z tractor & 60” deck, number 926378
Super Z tractor & 52” deck, number 926485
Super Z tractor & 52” deck, number 926493
Super Z tractor & 72” deck, number 926436
Super Z tractor & 72” deck, number 926444
Controls Hustler Z Tractor Owner Manual
For general location of the controls described in this section, refer to Figure 3-1. 1. Ignition switch (Fig. 3-2) – a three position switch: off, run, and start. With key inserted, rotate it
clockwise to START position; release key when engine starts, and switch will automatically return to the RUN position. 2. Throttle control (Fig. 3-2) — a cable is linked to engine throttle for controlling engine speed. Move 3. Start the engine and allow it to warm up to operating temperature. 4. With the deck clutch switch down and the control levers in the brake position, slowly raise off of the seat. The engine should continue to run. 5. With the deck clutch switch up and/or the control levers in the neutral position, slowly raise off of the seat. The engine should stop within two seconds. 6. If the engine fails to stop when the deck clutch switch
is up or one or both of the control levers is up and the operator is off the seat, check the function of the seat switch. If the seat switch is not operating properly (is not opening or closing) and if the cause can not be determined, replace the seat switch. 5. Deck clutch switch (Fig. 3-2) — this switch engages the deck. Pull the switch up to engage and push switch down to disengage the clutch. IMPORTANT: Never engage clutch with engine running at high rpm or when the deck is under load. Clutch, belts or deck could be damaged. 6. Deck lift pedal (Fig. 3-4) — the deck lift pedal is used to raise or lower the deck. Push on the pedal to raise the deck and then place the deck height locking pin into the desired cutting height hole. Push the deck lift pedal to raise the deck when going over obstructions. Hustler Z Tractor Owner Manual Pdf Download
Get the file Download here | PDF-HOME