C64 CNC Controller
Communication Protocol
Ethernet: Winsock V1.1 or higher.
TCP/IP
Supported Communication Parameters
Binary Format only.
Model
Mitsubishi C64 with AJ71QE71 compatible Ethernet module.
Device ID
Device IDs are specified as YYY.YYY.YYY.YYY where YYY designates the device IP address. Each YYY byte should
be in the range of 0 to 255.
32-Bit Data-First Word Low
Two consecutive registers addresses in a Mitsubishi device are used for 32 bit data types. Specify whether the
driver should assume the first word is the low or the high word of the 32-bit value. The default is first word low.
Connection Timeout
This parameter specifies the time that the driver will wait for a connection to be made with a device. Depending
on network load the connect time may vary with each connection attempt. The default setting is 3 seconds. The
valid range is 1 to 60 seconds.
Request Timeout
This parameter specifies the time that the driver will wait on a response from the device before giving up and
going on to the next request. Longer timeouts only affect performance if a device is not responding. The default
setting is 1000 milliseconds. The valid range is 50 to 30000 milliseconds.
Retry Attempts
This parameter specifies the number of times the driver will retry a message before giving up and going on to the
next message. The default setting is 3 retries. The valid range is 1 to 10.
Free Download Mitsubishi CNC Ethernet Driver Help
Get the file Download here | PDF-HOME