Overview
The Mitsubishi CNC Ethernet Device Driver was designed specifically for use with 32 bit OPC server products running on
Intel microprocessor based computers. For operating system (OS) requirements, please refer to the OPC server help
documentation.
Device Setup
Supported Devices
C64 CNC Controller
Communication Protocol
Ethernet: Winsock V1.1 or higher.
TCP/IP
Supported Communication Parameters
Binary Format only.
Model
Mitsubishi C64 with AJ71QE71 compatible Ethernet module
Device ID
Device IDs are specified as YYY.YYY.YYY.YYY where YYY designates the device IP address. Each YYY byte should be in
the range of 0 to 255.
32-Bit Data-First Word Low
Two consecutive registers addresses in a Mitsubishi device are used for 32 bit data types. Specify whether the driver
should assume the first word is the low or the high word of the 32-bit value. The default is first word low.
Connection Timeout
This parameter specifies the time that the driver will wait for a connection to be made with a device. Depending on
network load the connect time may vary with each connection attempt. The default setting is 3 seconds. The valid
range is 1 to 60 seconds.
Request Timeout
Free Download Mitsubishi Ethernet CNC Device Driver Help Manual PDF
Get the file Download here | PDF-HOME